Coil wire 's on Sov.GT

[XT18000]

Is there ANYONE out there that knows what color wire go's on what pin for the stock SovGT coil?
I am hooking up a VOM to mine and found out after I had cut off the plug and un-soldered the stub's
on the plug that MineLab is not useing the same wire they use to use ; so now I can't finish the hook-up
untill I find out what go's where. This wire has only four wire's where the older one's had five.
Old wire was Pin 1 red, Pin 2 black, Pin 3 green, Pin 4 orange, Pin 5 no used, Pin 6 blue.
Don't think I can make the VOM work with only four wire's; any idea's??????
New wire has Red, Black,Yellow, White. Pin's five and six are not used. Why???????

 

[Beachcomber]

The Blue wire is the TID wire and the signal actually comes from the detector so it doesn't need to be in the coil wire. On the GT it's only there in the wire that goes from the detector to the meter. The Red and Black wires are the same on the GT as on all past Sov's. The White goes to pin 3 and the Yellow Wire goes to pin 4.

HH

Beachcomber

 

[XT18000]

Thanks for your reply Beachcommer. I went ahead and ordered a Minelab meter and sent the coil in to
have the plug replaced. Will file your infomation in case I need it at some latter date. Thanks again!