Close up of CZ mount for John (Tx)

[therover]

John,

Here is a close up of the mount. Like I said in my PM, all I did was cut off the mounting bracket from a old CZ stock shaft, drilled out holes on the one side, and attached it to a straight shaft I already had. Had to drill out holes in the straight shaft as well.

Attached with 1/4 inch nuts and bolts.

John

 

[John(Tx)]

appreciate the help very much. I think the balance would be alot better with this set up. Thanks, John

 

[Dan-Pa.]

Again any ideas on how to mod a pinpoint on top as to me the pinpoint is a valuable tool and would make this a super mod and as is tough to get at pinpoint in this position.All ideas welcome and appreciated...Sure helps the ergonomics and weighting of a fine unit....

 

[EZrider]

Dan, i wonder if someone couldn't use a camera shutter activator? Sorry no cluewhat it's called. It's a cable looking thing that mounts over a camera shutter button.