Can you guys show me some pictures of your Sovereign GT with the Minelab meter and Sun-Ray probe hooked up.

[JASONSPAZ1]

I recently found a website of Custom Rods by plugger. Bill is a super helpful guy and has some great deals on Sovereign accessories. I have a few options to mix and match how I would have the S-1 probe and the Minelab Digisearch meter( if I get a meter) hooked up on the rod of the GT. I was wondering if some of you can post some pics of how you have your Sovereign GT setup with the digisearch meter and the S-1 probe.

Thanks so much in advance
take care
HH
Jason

 

[kered]

The probe box goes on the v clip and then the meter clips ontop of the probe box, i have mine on top of the handle so the switch is at hand and you can also see the meter, i will take a pic tomorrow if no one posts before hand

 

[plugger]

n/t

 

[matthias]

Greetings from a GT newbie. I obviously didn't over think this set up, but it worked well for me. Both the S-1 and the meter are connected to v-clips which are fastened to the shaft and handle with screws. The probe just sits (and stays) where you see it. Hope this helps you somehow. HH. Matt

 

[dbsmokey]

Nice setup matthias!

 

[JASONSPAZ1]

Thanks for showing your GT. I hope more of you show your GT setup with an S-1 and Digisearch.