A lot of you know I've been working on a nice detector stand for the ATpro, Ace 150,250 and 350. The real problem is getting a stand wide enough to keep the machine from falling over even on uneven ground. Once you get the stand that wide it hits you in the leg. Then if you make or buy a heavy chunky looking pipe stand to looks funky. I have made three types of nice aluminum stands in hopes of selling them. But after many field tests I cannot come up with a great stand. So I didn't give up though! I though way out of the box on this one. Guess what? It's the bomb! Here is the problem - I bought 3 parts that are in every hardware store. You don't even need any tools. Nor do you need to cut or alter a thing. Just put it on. I have to say it's so simple and works great. Cost $2.00 and it installed in 5 seconds. No drilling either. So what is the problem you say? Well I wanted to make some money on it. 
But I fear that once someone buys it they will say they go screwed. 
After all the local hardware store sells everything. So I guess you would be paying for a service of me gathering the materials. But who wants to do that? Probably not many? So what do you say? Do you just want me to show a picture and parts list? I'm pretty sure what the answer will be....
But I fear that once someone buys it they will say they go screwed. After all the local hardware store sells everything. So I guess you would be paying for a service of me gathering the materials. But who wants to do that? Probably not many? So what do you say? Do you just want me to show a picture and parts list? I'm pretty sure what the answer will be....
..I have lots of good ideas but I also run into the same problem....Good luck on your decision....JJ